Any brand bearing press will work as long as the correct size bearing drifts are used. DO NOT HAMMER OUT BEARINGS - This can lead to a debonded hub shell.

First start by removing the hub end caps. Pull firmly to remove.

Using your bearing press, place the axle press tool on the disc side axle sleeve, this will press the axle through the hub

Place the bearing removal cup on the non-disc side, this cup should be larger in diameter than the bearing

Slide the threaded rod through the hub, install the handles

Make sure the axle press tool and bearing removal cup are centered

Tighten the tool handles to press the axle and the non-disc side bearing out of the hub shell

Remove bearing from axle sleeve

Insert the axle sleeve back into the hub to press out bearing on disc side

Insert threaded rod through bearing press and axle sleeve

Place the bearing removal cup on the disc side, this cup should be larger in diameter than the bearing

Tighten the tool handles to press the axle and the disc side bearing out of the hub shell

Slide the remaining bearing onto the axle sleeve

Insert the axle sleeve into the non-disc side of the hub shell

Put the handle back on the rod and tighten the tool to press the non-drive side bearing in, capturing the axle between the bearings

Re-install axle end caps