Site Navigation

Your Account

Choose Language

Tools

Parts

No parts required.

  1. Start by installing the correct size bash guard for your chainring size
    • Start by installing the correct size bash guard for your chainring size

      • The smallest guard fits 28-30t chain rings

      • The middle guard fits 32-34t chain rings

      • The biggest guard fits 36-38t chain rings

    • Tighten the fixing screws to 0.9N*m using a T25 Torx wrench

    Add Comment

  2. Start by opening upper slider
    • Start by opening upper slider

      • Open the metal clip on the upper slider

      • Flip the clip open

      • Release the latch and rotate the upper slider open

    Add Comment

    • Loosen the lower slider bolt using a T25 Torx wrench

    • Pull the bolt out slightly and rotate the lower slider open

    Add Comment

    • Remove cranks from the bike

    • Install the guide onto your frame or ISCG adapter (if one is needed) using the supplied T25 screws

      • It is recommended to use the longest screws possible to provide the strongest connection to the frame - two lengths are provided

    • Lightly tighten the screws until the backplate is snug against the frame

    Add Comment

    • Slide the cranks back into the BB and re-install per manufacturer’s recommendations

    • Sight down the front of the guide to check if the guide is centered over the chain ring

    Add Comment

    • If needed, use the provided ISCG05 C-spacers or washers to move the guide out from the frame until it is centered over the guide

      • It may be necessary to remove the cranks to adjust the guide. However, in many cases it is possible to reach a T25 torx wrench through the chain ring to tighten and loosen the ISCG mounting screws.

      • If using the C-spacers, removing the middle screw will make adjustments easier, just remember to replace it once you are satisfied with the guide placement!

    Add Comment

    • When the guide is centered over the chain ring, rotate the guide such that the upper slider fixing bolt is in the 12 o’clock position

    • Tighten the ISCG mounting screws to 6N*m using a torque wrench

    Add Comment

    • It may be necessary to adjust the lower armature to provide additional clearance for the lower slider on some bikes

    • Remove the two lower armature screws and relocate the lower armature as necessary

    • Tighten the two lower armature screws to 6N*m with a T25 Torx wrench

    Add Comment

    • Install the chain onto the chain ring

    • Close the upper slider and clip the latch closed

    Add Comment

    • Thread the chain over the lower roller

    • Rotate the lower slider closed

    • Position the lower slider such that the arrow is in line with the bottom of the chain and tighten the screw to 0.9N*m

    Add Comment

Conclusion

Thanks for reading, now get out there and ride!

The Hive

Member since: 12/05/2012

51 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 8

Past 7 Days: 31

Past 30 Days: 174

All Time: 6,469